![]() I just commented out the g-code line and it cut the roughing pass perfectly on the board. I found that something is adding to the G-code a G53 code that sets Z-10 at the beginning and end which would have broken the 1/8" roughing bit had I not done a "bit not installed" test cut. I still had a couple of problems but I think I'm on the right track. Today, I had my first semi-successful cut (used a test board same size before I make the large brass stamp). So how do I start a new, I think they call it a thread, to ask the question of how to clear this Fusion 360 error for out of date tool paths an get my simple block toolpaths edited and over to G-code so I can run on some program like Universal G-Code Sender or Openbuilds CAM (preferred)? Maybe that has already been answered and you can point me in the right direction. ![]() ![]() But you did answer my original question and I REALLY REALLY thank you. And their forum is two orders of magnitude more complex to navigate than this one, especially for someone who asked their first question 3 days ago on this forum. Every time I try, it just makes new Setups but I can't get back to the setup menus for toolpaths. But I won't know it worked until I can get it to make some tool paths and G-code.īut now it keeps telling me my tool paths are out of date and won't let me save anything till I update them. It then allowed me to select OpenbuildsGRBL.cps in the post process folder. ![]() Also, they don't tell you but you have to copy the file it into the New Post Process folder and not just into Assets directory (they don't tell you that). I enabled cloud preferences and figured out that the example they give in the link is not up to date on their website.
0 Comments
Leave a Reply. |